The reason of roller slipping of pellet making machine

If the roller of pellet making machine skids when using, it would not affect the quality and quantity of pellets produced seriously. We must pay attention to this problem in time, so as to ensure the production efficiency and production quality of pellet making machine. Then, what are the reasons of roller slipping of pellet making machine?



1. The bearing installed is not flexible enough.
Do not install the bearing of biomass pellet machine too tight, otherwise it would cause the slip of roller in the operation. The best way to solve this problem is to keep an eye on the rollers, even if you replace them with new ones.
2. Excessive moisture of raw materials.
If the moisture content of raw materials is higher when processing, it would lead to the slipping of roller due to the lubrication of water.
The best way to solve this problem is to reduce the inflow of steam from raw materials and keep the water contained in the materials within a reasonable range.
3. The clearance of roller is too large.
When using the pellet making machine, if there is no good control of the clearance between the roller, it is easy to make the pellets produced not uniform, the yield is small, and the pellet machine can not press the material tightly.
The best way to solve this problem is to narrow the distance between the two spindles.
4. Excessive use of roller.
After being used for a long time, the roller of biomass pellet machine would wear (a basic type of parts failure), which would also lead to the sliding phenomenon and it can not normally work.
A good way to solve the problem is not only to often keep the pellet making machine cleaning, but also replace the new roller at any time.
-----------------------------------------------------------------------------------------------------------------------------------------------------