How to deal with the powdery material compressed by the pellet machine?
There are three reasons for the powdery material or basically no pellets but all powdery material in the pellet when compressed by the pellet machine. They are compression ratio of mold, moisture content of material and the machine testing.
Moisture content of raw material
Moisture content is considered to be an important factor to ensure pelletizing efficiency. According to experts, it's important to control moisture content before feeding raw material to the hopper. In addition to this, moisture content should be uniform for the material.
Too large or too small of moisture content of raw material can cause the powdery situation. The pellet can not be formed with big size powdery material if moisture content is large. The pellet has much small fines if the moisture content is small. The most proper moisture content for compressing of pellet machine is about 15%. The specific moisture requirement should be on the basis of feedstock.
The compression ratio of the die
Compression ratio refers to the actual diameter or lengths of ring die holes. In theory, when the compression ratio is larger, the output of the pellet machine is better. One drawback of compression ratio is that the discharging speed may be low and the holes may be easily blocked.
If the compression ration of the mold is improper, the machine can not give enough pressure to the straw material and time for formation. It leads to the material flowing out from the machine without compressing which causes the powdery of pellet.
As for the above reasons, the method for solving is simple.
1.Take good control of moisture content of material. Add a drying process when the material has high moisture content.
2.The compression ratio of die can not be changed. The simple way is to change the die. Several types of die are suggested for testing for finding the best proper one.
3.Installment and testing of pellet mill. It is necessary to install and test the machine by the manufacture with active cooperation with the producer.
KMEC of He Nan province are professional manufactures of pellet machine, wood pellet mill, straw pellet mill, sawdust crushing machine and other biomass new energy equipment. Our products have been exported to foreign countries which have been approved by our clients. Welcome to investigate our company.
-----------------------------------------------------------------------------------------------------------------------------------
News
- Small Pellet Machine Manufacturer-Kingman
- Application of Wood Pellets and Use of Biomass Pellets
- From Fossil Fuel into Biomass Pellet Fuel
- Biomass Pellet Making Machines Market
- Applying of pellet stoves for home use
- Highland pellets to build $130 million facility in arkansas
- How to deal with the blocked hammer mill
- How to Make Wood Pellets with Sawdust
- The government policy promotes the development of biomass fuel
- Market analysis of biomass pellet fuel
- Strategic positioning of renewable energy
- Biomass energy has pass through the pre assessment
- The key point of deep processing of biomass pellet
- Harbin is promoting the development of biomass machinery
- The development of biomass formation technology I
- The development of biomass formation technology II
- Biomass energy industry is now going full tilt in 2015
- Rapid increasing demand of sawdust pellet on the market
- Pellet fuel market in EU
- Chinese Biomass Energy Conference held in Beijing
- Future market development of straw pellet mill
- Peanut Shell Pellet Mill Makes High Quality Pellets
- The utilization of straw is only 5%, biomass energy needs our attention!
- Corn straw pellet machine relieves the tight supply of fuel energy
- Reasons for loose or not forming of biomass pellet mill